UTG PRO P.O.I. Mounting rings Ø34mm - BH 15mm

Latest design allows smaller size and lower weight

UTG PRO P.O.I. Mounting rings Ø34mm - BH 15mm

• Made in the USA
• POI® (Precision Optics Interface) rings have a center height of 32 mm to accommodate optics with a 34 mm tube and a outer lens of up to 63mm to attach
• Innovative P.O.I® (Precision Optics Interface) addresses three of the most critical areas of oscilloscope rings
  1. a) progressively machined for a precise inner ring surface for a seamless ring-to-scope interaction
  2. b) Flat and flush locking side plate controlled by two spring-loaded guide rods and fitted to the rail with the Torx screw lock for a safe and repeatable To ensure zero stop
  3. c) Square integral recoil stop connected by full surface contact with a picatinny slot to eliminate the possibility of forward and backward motion due to recoil vibrations 

• 2-piece ring set with 4 upper Torx screws each with a ring width of 22 mm
• Fits Picatinny after Mil-Spec from 1913
• Made of 6061-T6 aluminum alloy and 4605 steel with a matte black hard coating
• UTG PRO® Original Snag-free Contoured profiles with lower weight and lower

  Size NOTE: We recommend tightening the top eye bolts with a torque of approx 2.8 Nm and tighten the side plate bolt to a torque of approximately 5.1 Nm.

   

  Specification: 2 rings / set 4 Torx screws per ring Saddle height: 15mm Ring diameter: 34mm Ring width: 22mm Max. Lens outside diameter: 63mm Color: Matt Black Material: 6061-T6 aluminum and 4605 steel Mass. 73,7g

Detail:

Overall height: 15 mm

Preference: 0 MOA / 0 MIL

Execution: mounting rings

Mounting: Screw fastening

center tube diameter: Ø34 mm